Drying a structure correctly isn't about running a few fans and hoping — it's a calculated process based on temperature, humidity, and airflow readings.
Our Pomona, KS drying plans start with thermal imaging to map exactly where moisture is hiding.
We calculate drying requirements using temperature and humidity data, not a flat per-room rule.
LGR capacity is standard equipment on every Structural Drying And Dehumidification job, not a premium upgrade.
Thermal imaging cameras reveal moisture patterns behind walls and under flooring that aren't visible to the eye.
Daily logs give you and your insurer verifiable proof of progress, not a technician's word.
Here's the full scope of a Structural Drying And Dehumidification job in Pomona, from initial scan to final verification.
The assessment sets the baseline every later reading gets measured against.
We map the full extent of moisture intrusion before placing a single air mover.
Dehumidifier capacity is matched to the calculated moisture load for that specific space.
Daily monitoring confirms equipment is working and adjusts the plan if progress stalls.
Specialty drying protocols protect materials that standard drying speed could damage.
We provide a written verification report confirming the structure has reached dry standard.
We ask enough to bring the right instruments on the first visit.
Our nearest Pomona, KS crew brings diagnostic equipment loaded from the start.
You'll see the calculated plan and cost before drying equipment goes down.
We verify final moisture readings against dry standard before removing equipment.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
A room can look dry on the surface while moisture meters still detect trapped moisture inside materials.
It's a calculated approach using temperature and humidity data to determine exact equipment needs, rather than guessing.
Typical drying time is 3-5 days for standard materials, longer for sensitive ones like hardwood.
We provide daily documented logs showing moisture readings, not just a verbal update.
Yes, we use slower, controlled drying specifically calibrated for hardwood to prevent warping.
A stall in the daily logs triggers a plan review rather than simply leaving equipment running unchanged.
Pomona is within our core structural drying response zone.
One call starts the psychrometric assessment process.
Call +1-844-833-1325